Cisco 300 Series 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 300 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 300 Series 17 페이지. Managed switches
Cisco 300 Series에 대해서도 마찬가지입니다: 데이터시트 (14 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (17 페이지)

페이지 인쇄

Some switches have a higher temperature rating. The SG300-

OTE

10SFP, SG300-52P and SG300-52MP are rated at 113 degrees

Fahrenheit (45 degrees Centigrade), and the SG300-28MP, and SF300-

24MP are rated at 122 degrees Fahrenheit (50 degrees Centigrade).

Reduced Air Flow—Both side panels must be unobstructed to prevent

overheating.

Mechanical Overloading—The device should be level, stable, and

secure to prevent it from sliding or shifting out of position.

Circuit Overloading—Adding the device to the power outlet must not

overload that circuit.

Rack-Mount Placement

Remove the four screws from each side near the front of the switch.

TEP

Retain the screws for re-installation. (Do not remove the four screws

from each side near the back of the switch.)

Place one of the supplied spacers on the side of the switch so the

TEP

four holes of the spacers align to the screw holes. Place a rack

mount bracket next to the spacer and reinstall the four screws

removed in

If your screws are not long enough to reattach the bracket with

OTE

the spacer in place, attach the bracket directly to the case without the

spacer.

Repeat

TEP

After the mounting hardware has been securely attached, the

TEP

switch is now ready to be installed into a standard 19-inch rack.

300 Series Managed Switches

Step

Step 2

for the other side of the switch.