Release Notes for the Cisco Catalyst
Blade Switch 3020 for HP,
Cisco IOS Release 12.2(50)SE and Later
Revised August 13, 2009
Cisco IOS Release 12.2(50)SE and later runs on the Cisco Catalyst Blade Switch 3020 for HP, referred
to as the switch. Unless otherwise noted, the term switch refers to a standalone switch.
http://www.cisco.com/en/US/products/ps8743/prod_release_notes_list.html
If you wish to use Device Manager to upgrade the switch from Cisco IOS Release 12.2(35)SE through
Note
Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release 12.2(50)SE or later (the IP
base image), you must first upgrade to Cisco IOS Release 12.2(40)SE2.
These release notes include important information about Cisco IOS Release 12.2(50)SE and any
limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct for
your switch:
•
If you are installing a new switch, see the Cisco IOS release label on the switch packaging.
•
If your switch is on, use the show version privileged EXEC command. See the
Software Version and Feature Set" section on page
•
If you are upgrading to a new release, see the software upgrade filename for the software version.
See the
"Deciding Which Files to Use" section on page
For the complete list of Cisco Catalyst Blade Switch 3020 for HP documentation, see the
the Getting Started Guide" section on page
You can download the switch software from this site (registered Cisco.com users with a login password):
http://tools.cisco.com/support/downloads/go/MDFTree.x?butype=switches
This software release is part of a special release of Cisco IOS software that is not released on the same
8-week maintenance cycle that is used for other platforms. As maintenance releases and future software
releases become available, they will be posted to Cisco.com in the Cisco IOS software area.
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2009 Cisco Systems, Inc. All rights reserved.
3.
4.
24.
"Finding the
"Updates to
페이지 인쇄