Cisco 3750 - Catalyst EMI Switch 시작하기 매뉴얼 - 페이지 20

{카테고리_이름} Cisco 3750 - Catalyst EMI Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3750 - Catalyst EMI Switch 27 페이지. Catalyst 3750 series switches
Cisco 3750 - Catalyst EMI Switch에 대해서도 마찬가지입니다: 데이터시트 (18 페이지), 설치 매뉴얼 (47 페이지), 자주 묻는 질문 (10 페이지), 제품 게시판 (5 페이지), 제품 지원 게시판 (6 페이지), 제품 개요 (25 페이지), 설명 (1 페이지), 데이터시트 (23 페이지), 제품 지원 게시판 (6 페이지), 데이터시트 (23 페이지), 시작하기 매뉴얼 (33 페이지)

페이지 인쇄

Cisco 3750 - Catalyst EMI Switch 시작하기 매뉴얼

Install the SFP Modules and Connect to the Ports

Follow these steps:

Grasp the module on the sides, and

Step 1

insert it into the switch slot until you

feel the connector snap into place.

Insert an appropriate cable into the

Step 2

module port. Insert the other cable

end into the other device.

For a list of supported modules, see the release notes on Cisco.com. For detailed instructions on

installing, removing, and connecting to SFP modules, see the documentation that came with the

SFP module.

Removing and installing an SFP module can shorten its useful life. Do not remove and

Caution

insert SFP modules more often than is absolutely necessary.

Verify Port Connectivity

After you connect to the switch port, the port LED turns amber while the switch establishes a link.

This process takes about 30 seconds. Then the LED turns green when the switch and the target device

have an established link. If the LED is off, the target device might not be turned on, there might be a

cable problem, or there might be a problem with the adapter installed in the target device. See the "In

Case of Difficulty" section on page 22 for information about online assistance.

13 X

14 X

SFP module

13 X

14 X

SFP module port

C a ta ly st 3

7 5 0 G

SE RI ES

P o E -2 4

23 X

2 5

2 7

2 6

24 X

2 8