Cisco 3750G - Catalyst Integrated Wireless LAN Controller 시작하기 매뉴얼 - 페이지 16
{카테고리_이름} Cisco 3750G - Catalyst Integrated Wireless LAN Controller에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3750G - Catalyst Integrated Wireless LAN Controller 49 페이지. Integrated wireless lan controller switch
Cisco 3750G - Catalyst Integrated Wireless LAN Controller에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지)
페이지 인쇄
From the LWAPP Transport Mode drop-down box, choose Layer 3. The controller
Step 16
operates only in Layer 3 mode.
(Optional) In the RF Mobility Domain Name field, enter the name of the mobility group/
Step 17
RF group to which you want the controller to belong.
Although the name that you enter here is assigned to both the mobility group and the RF
group, these groups are not identical. Both groups define clusters of controllers, but they
have different purposes. All of the controllers in an RF group are usually also in the same
mobility group and the reverse. However, a mobility group facilitates scalable,
system-wide mobility and controller redundancy, while an RF group facilitates scalable,
system-wide dynamic RF management.
In the Country Code field, enter the code for the country in which the controller will be
Step 18
used. See the table below the Country Code field for the list of available country codes.
Step 19
Click Next. The AP Manager Interface Configuration page appears.
Enter the VLAN identifier, the IP address, the netmask, and the gateway for the controller
Step 20
AP-manager interface.
The AP-manager interface is used for Layer 3 communications between the controller and
lightweight access points and must have a unique IP address. It is usually configured on
the same VLAN or IP subnet as the management interface, but this is not a requirement.
16