Cisco 400 Series 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Cisco 400 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 400 Series 8 페이지. Fasthub 10/100 series
Cisco 400 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지)

페이지 인쇄
Cisco 400 Series 빠른 시작 매뉴얼
(Optional) Display the FastHub 400 Series
Hub Manager
If you have the IP address to the hub, you can display the FastHub 400 series Hub Manager
from your intranet. You can use the FastHub 400 series Hub Manager to configure and monitor
the hub.
Start Netscape Communicator (4.03 or higher) or Microsoft Internet Explorer
1
(4.01 or higher). Make sure that Java and JavaScript are enabled.
Enter the IP address of the hub in the URL field if you are using Communicator
2
(the Address field if you are using Internet Explorer).
The FastHub 400 series Hub Manager Home page appears.
Click Apply after
making changes
on a page.
Click Revert
to discard
unapplied
changes on
a page.
Click Help for
procedures and
detailed field
descriptions.
Click the Mode
button to change
the mode that
the LEDs display
for the fixed
10/100 ports.
Note: The FastHub 400 10/100 Series Installation and Configuration Guide and the
FastHub 400 10/100 series Hub Manager online help provide complete information about the
web console and describe how to configure and monitor the hub.
HOME
PORT GROUP IP SNMP CDP SYSTEM
Click these topics to move from page
to page. On Netscape Communicator
only, when the cursor is above a topic,
a pop-up briefly describes the options
on that particular page.
Click a port to display its
settings, status, and statistics.
Click to display the settings, status, and
statistics of an installed 10BaseT/100BaseTX
or 100BaseFX switched uplink module.
Shows when another hub is connected to a
stacking connector on the hub rear panel.
6