Cisco 4500-M 업그레이드 매뉴얼 - 페이지 20

{카테고리_이름} Cisco 4500-M에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4500-M 24 페이지. Upgrading memory
Cisco 4500-M에 대해서도 마찬가지입니다: 설치 매뉴얼 (18 페이지), 교체 매뉴얼 (16 페이지)

페이지 인쇄
Cisco 4500-M 업그레이드 매뉴얼
Memory Replacement Procedures
Caution
damaged by mishandling.
Step 2
Step 3
Figure 15
3.
4.
3.
4.
20 Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory
Handle SIMMs by the edges only. SIMMs are ESD-sensitive components and can be
Hold the SIMM with the polarization notch on the right and the component side away from
you with the connector edge at the bottom.
Referring to Figure 15, insert the Flash memory SIMM at a 45-degree angle and rock it into
its vertical position. (See Figure 8 on page 12.) When the SIMM is properly seated, the
socket guide posts will insert through the alignment holes, and the locking springs will
click into place. Use the minimum amount of force required.
Inserting Flash Memory SIMMs
1. Insert the SIMM into the socket at an angle 45° from vertical.
2. Push the SIMM down and back.
The socket guide posts insert
through the SIMM holes
(on both sides).
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
1. Insert the SIMM into the socket at an angle 45° from vertical.
The socket guide posts insert
through the SIMM holes
(on both sides).
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
Top view
Front of the chassis
Side view
2. Push the SIMM down and back.
Polarization
notch