Cisco 4506 - Catalyst Switch 개요 - 페이지 24
{카테고리_이름} Cisco 4506 - Catalyst Switch에 대한 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4506 - Catalyst Switch 46 페이지. Promotional bulletin
Cisco 4506 - Catalyst Switch에 대해서도 마찬가지입니다: 설명 (2 페이지), 사용 설명서 (2 페이지), 데이터시트 (23 페이지), 제품 지원 게시판 (4 페이지), 보충 설명서 (3 페이지)
페이지 인쇄
Ethernet and Fast Ethernet Switching Modules
Note
WS-X4232-GB-RJ
Catalyst 4500 Series Module Installation Guide
1-24
To provide PoE with the 48-port PoE 10/100BASE-TX switching module in a
Catalyst 4006 switch, you must have a power entry module (PEM) and a power
shelf installed. The Catalyst 4006 switch can provide 312 W per PoE module to
powered devices. If the powered devices are using the maximum 15.4 W per port,
there is only enough power for 18 powered devices. If the powered devices are
using less than 15.4 W per port, more powered devices can be powered, up to the
312 Watt maximum. For more information about installing the PEM or the
external power shelf, refer to the Catalyst 4000 Series Installation Guide,
Catalyst 4500 Series Installation Guide, Installation and Configuration Note for
the Catalyst 4500 Series AC Power Shelf, or the Catalyst 4500 Series Power Entry
Module and External Power Shelf Installation Note.
To provide PoE with the 48-port PoE 10/100BASE-TX switching module in a
Catalyst 4500 series switch, you must have a PoE-enabled power supply. All
power supplies support PoE except the 1000 W and 1400 W AC power supplies.
Auto MDIX is not supported on PoE enabled switching modules.
The WS-X4232-GB-RJ 34-port Ethernet switching module (see
the following specifications:
Specification
Module type
Port duplex mode
Port speed
Number of ports
Chapter 1
Description
10/100BASE-TX Ethernet plus 1000BASE-X Gigabit
Ethernet switching module
Half or full duplex mode on the 10/100BASE-TX
ports
Full duplex mode on the 1000BASE-X ports
10, 100, and 1000 Mbps
32 10/100BASE-TX ports
1
2 1000BASE-X
ports
Module Overview and Specifications
Figure
1-23) has
78-13267-06