Cisco 4510R - Catalyst Switch 개요 - 페이지 3

{카테고리_이름} Cisco 4510R - Catalyst Switch에 대한 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4510R - Catalyst Switch 46 페이지. Line cards
Cisco 4510R - Catalyst Switch에 대해서도 마찬가지입니다: 설명 (2 페이지), 사용 설명서 (2 페이지), 데이터시트 (23 페이지)

페이지 인쇄
Cisco 4510R - Catalyst Switch 개요
Chapter 1
Module Overview and Specifications
The supervisor engines have the following features:
•
•
•
•
•
•
•
To install a supervisor engine, follow the procedure in the
Modules" section on page
The supervisor engines used in Catalyst 4000 and Catalyst 4500 switches are
shown in
78-13267-06
Data path and control for all network interfaces
Management functions:
Interface monitoring
–
Environmental status
–
SNMP and console/Telnet interface
–
Hot-swapping
Note
Packets are not forwarded while the module is removed. A system
reboot occurs when a supervisor engine is reinserted.
The Supervisor Engine II-Plus TS provides 12 nonblocking
10/100/1000BASE-T (RJ-45) ports and 8 1000BASE-X (SFP) ports.
The Supervisor Engine II-Plus 10GE and Supervisor Engine V-10GE provide
2 nonblocking 10GBASE uplink ports.
The Supervisor Engine II-Plus 10GE and Supervisor Engine V-10GE provide
4 1000BASE-X (SFP) ports.
The Supervisor Engine IV and V support the Catalyst 4500 series NetFlow
Services Card (WS-F4531). NetFlow is integral to the Supervisor Engine
V-10 GE.
Figure 1-1
to
Figure
3-2.
1-8.
Catalyst 4500 Series Module Installation Guide
Supervisor Engines
"Installing the
1-3