Cisco 4908G-L3 - Catalyst Switch 매뉴얼 - 페이지 15

{카테고리_이름} Cisco 4908G-L3 - Catalyst Switch에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4908G-L3 - Catalyst Switch 19 페이지.

페이지 인쇄

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Pinouts

Signal

RTS

Output

DTR

Output

TXD

Output

Ground

RXD

Input

DSR

Input

CTS

Input

Catalyst 6000/6500 Supervisor Engine I, II and 720

Console Port Signals and Pinouts

The Catalyst 6000/6500 family switch comes with an accessory kit that contains the cable and adapters

you need to connect a console (an ASCII terminal or a PC running terminal emulation software) or

modem to the console port. The accessory kit includes these items:

RJ-45-to-RJ-45 rollover cable

RJ-45-to-DB-9 female DTE adapter (labeled "Terminal")

RJ-45-to-DB-25 female DTE adapter (labeled "Terminal")

RJ-45-to-DB-25 male DCE adapter (labeled "Modem")

These are the same cable and adapters that ship with the Cisco 2500 series routers and other Cisco

products.

Console Port Mode Switch

The Supervisor Engine front-panel console port mode switch allows you to connect a terminal or modem

to the console port as follows:

Note: Use a ball-point pen tip or other small, pointed object to access the console port mode switch. The

switch is shipped in the in position.

Mode 1: Switch is in the in position. Use this mode to connect a terminal to the console port using

the RJ-45-to-RJ-45 rollover cable and the data terminal equipment (DTE) adapter (labeled

"Terminal"). You may also use this mode to connect a modem to the console port using the

RJ-45-to-RJ-45 rollover cable and the data communications equipment (DCE) adapter (labeled

"Modem"). See

http://www.cisco.com/warp/public/473/9.html (15 of 19) [9/4/2003 12:36:03 PM]

Direction

Request To Send

Data Terminal Ready

Transmit Data

Receive Data

Data Set Ready

Clear To Send

Console Port Mode 1 Signaling and

Description

Pinouts.