Cisco 6509-NEB - Catalyst Switch 업그레이드 매뉴얼 - 페이지 12
{카테고리_이름} Cisco 6509-NEB - Catalyst Switch에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6509-NEB - Catalyst Switch 24 페이지. Catalyst 6500 series chassis and module power and heat values
Cisco 6509-NEB - Catalyst Switch에 대해서도 마찬가지입니다: 데이터시트 (30 페이지), 기술 정보 (16 페이지)
페이지 인쇄
Replacing the Power Supply
Installing the 3000 W AC-Input Power Supply
Use both hands to install and remove power supplies. Each Catalyst 6500 series AC-input power supply
Caution
weighs between 22 pounds (9.9 kg) and 28 pounds (12.6 kg).
To install the 3000 W AC-input power supply, follow these steps:
Step 1
Ensure that the system (earth) ground connection has been made. For ground connection instructions,
refer to the installation guide for your hardware platform.
Step 2
Verify that the power switch is in the Off (0) position on the power supply you are installing.
(See
Figure 7
Cable
etention
device
Power
switch
Grasp the power supply handle with one hand. Place your other hand underneath the power supply, as
Step 3
shown in
is fully seated in the bay.
Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note
12
Figure
7.)
3000 Watt AC-Input Power Supply Front Panel
AC power
connection
110-12 0V - 15A
200-24 0V - 15A
60/50H Z
I
O
INPUT
FAN
OUTP UT
OK
OK
FAIL
Captive installation
Status LEDs (3)
screw
Figure
8. Slide the power supply into the power supply bay. Make sure that the power supply
OUTP UT 42V /17A
42V /17A
OK
+
External power
connector cover
78-16162-02