Cisco 6509-NEB - Catalyst Switch 업그레이드 매뉴얼 - 페이지 21
{카테고리_이름} Cisco 6509-NEB - Catalyst Switch에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6509-NEB - Catalyst Switch 24 페이지. Catalyst 6500 series chassis and module power and heat values
Cisco 6509-NEB - Catalyst Switch에 대해서도 마찬가지입니다: 데이터시트 (30 페이지), 기술 정보 (16 페이지)
페이지 인쇄
Figure 17
RTN -48VDC GND
WS-C 6500- NEB- FAN2
Powering Up the System
This section describes how to power up the system.
•
•
AC-Input Systems
To power up your AC-input system, follow these steps:
Plug the power cord into the power supply, and tighten the screw on the cable retention device.
Step 1
Connect the other end of the power cord to an AC-input power source.
Step 2
In a system with dual power supplies, connect each power supply to a separate input source. In case of
Caution
a power source failure, the second source will most likely still be available.
Step 3
Turn the power switch to the On (|) position on the power supply. Switching the power switch to On also
engages a pawl that locks the power supply in the bay.
78-16162-02
Ejector Lever Closure in the Chassis
48V INPUT 1
HIGH SPE ED FAN
INPOUT POWER
GOOD
All ejector levers flush
with module faceplate
AC-Input Systems, page 21
DC-Input Systems, page 22
48V INPUT 2
FAN FAIL
INPOUT POWER
GOOD
RTN -48VDC GND
Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note
Powering Up the System
21