Cisco 7505 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Cisco 7505에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7505 32 페이지. 600w ac-input power supply and fan tray replacement
Cisco 7505에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (23 페이지), 설치 지침 매뉴얼 (15 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

Install the Hardware

Install Interface Processors, Fillers, VIPs, and RSPs

Card carrier guide (black)

Captive

installation

screw

The Route Switch Processor (RSP) comes uninstalled

with your Cisco 7505 router, but is a required system

component. Install the RSP in the RSP slot, and

install any interface processors, ﬁllers, or Versatile

Interface Processors (VIPs) in slots 0, 1, 2, and 3.

Step 1

Hold the interface processor, ﬁller, VIP, or

RSP with one hand, and place your other

hand under the carrier to support the card

and guide it into the slot. Avoid touching

the card.

Step 2

Place the interface processor, ﬁller, VIP, or

RSP in the slot and align the guide on the

carrier with the groove in the slot, as

shown in A.

Step 3

Carefully slide the interface processor,

ﬁller, VIP, or RSP into the slot until the

faceplate makes contact with the ejector

levers.

Step 4

Use the thumb and foreﬁnger of each hand

to push the ejector levers ﬂat against the

interface processor, ﬁller, VIP, or RSP, as

shown in B.

Step 5

Use a screwdriver to tighten the captive

installation screws, as shown in C.

Step 6

Repeat Step 1 through Step 5 to install the

RSP or any additional interface

processors, ﬁllers, or VIPs.

Note

Refer to the "Check the RSP Installation"

section on page 19 to check the RSP installation.

Refer to the "Check the Interface Processor or VIP

Installation" section on page 20 to check the

interface processor or VIP installation.