Cisco 7507 설치 지침 매뉴얼 - 페이지 16
{카테고리_이름} Cisco 7507에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7507 39 페이지. Air filter and chassis blower replacement
Cisco 7507에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지), 데이터시트 (11 페이지), 교체 지침 매뉴얼 (21 페이지)
페이지 인쇄
Installation
Installation
The following sections describe the procedures for mounting the chassis in a 19-inch equipment rack
with two or four mounting posts. Before proceeding, review the guidelines and recommendations in
the section "Prerequisites" on page 7 to protect your safety, to maintain sufficient clearance around
the rack during and after the installation, and to ensure proper airflow through the chassis after the
installation.
Warning
perform.
Some equipment racks provide a power strip along the length of one of the rear mounting strips. If
your rack has this feature, we recommend that you fasten the brackets and install the interface
processor end of the chassis at the opposite side of the rack.
Installing the Brackets
The two brackets are identical. The inner side of each bracket has a ledge at the bottom to support
the undersides of the chassis, and shielding to provide electrical isolation between the chassis and
the rack. A flange on the front of each bracket provides five mounting holes at the top, and three at
the bottom. Mount the bracket with the flange in front of the rack post, and with the inner (shielded)
side facing the center of the rack. The ledge should be at the bottom of the bracket. (See Figure 9.)
Figure 9
16 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions
To avoid potentially serious bodily injury, this procedure requires two or more people to
Positioning a Bracket
Flange
Rack post