Cisco 9124 - mds multilayer fabric switch 구성 매뉴얼 - 페이지 14

{카테고리_이름} Cisco 9124 - mds multilayer fabric switch에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 9124 - mds multilayer fabric switch 49 페이지. Mds 9000 series
Cisco 9124 - mds multilayer fabric switch에 대해서도 마찬가지입니다: 사양 (2 페이지), 데이터시트 (9 페이지), 사양 (3 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (22 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (40 페이지), 매뉴얼 (16 페이지), 하드웨어 설치 매뉴얼 (36 페이지)

페이지 인쇄
Cisco 9124 - mds multilayer fabric switch 구성 매뉴얼
C-Series IP Storage Services Modules (IPS-4, IPS-8),
Multi-protocol Services Module (14/2) and MDS 9216i
configuration constraints
C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services
Module (14/2) and MDS 9216i constraints
Table 1 C-Series iSCSI limits
iSCSI component
iSCSI host connections per port
Active LUNs per port
Number of Initiator/Targets (IT) Nexus per port
Number of active LUNs per IT Nexus
Number of IT Nexus/LUNs combinations per port
Examples of maximum configurations for IT Nexus:
•
200 iSCSI initiators each connected to one target (storage controller port)
•
100 iSCSI initiators each connected to two targets
•
50 iSCSI initiators each connected to two targets and 100 iSCSI initiators each connected to
one target

iSCSI host constraints

Table 2 iSCSI host limits for Windows 2003
iSCSI host component
Targets accessed per host
LUNs per target

Fibre Channel switch and fabric constraints

The C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2), and
MDS 9216i switch are supported on any currently supported HP Infrastructure C-Series switch fabric. For
the latest HP Infrastructure switch topologies and fabric rules, refer to the HP StorageWorks SAN design
reference guide, which can be downloaded from the following web site:
http://h18000.www1.hp.com/products/storageworks/san/documentation.html
Configuring SANs with C-Series switches and iSCSI in a
Windows environment
To configure the C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module
(14/2) and MDS 9216i switch in an HP Fibre Channel SAN:
1. Enable iSCSI on the C-Series switch
2. Present iSCSI hosts as virtual FC hosts
3. Install the Microsoft iSCSI initiator
14
Maximum
200
200
200
256
1200
Maximum
8
255