Cisco 9124 - mds multilayer fabric switch 구성 매뉴얼 - 페이지 30

{카테고리_이름} Cisco 9124 - mds multilayer fabric switch에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 9124 - mds multilayer fabric switch 49 페이지. Mds 9000 series
Cisco 9124 - mds multilayer fabric switch에 대해서도 마찬가지입니다: 사양 (2 페이지), 데이터시트 (9 페이지), 사양 (3 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (22 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (40 페이지), 매뉴얼 (16 페이지), 하드웨어 설치 매뉴얼 (36 페이지)

페이지 인쇄
Cisco 9124 - mds multilayer fabric switch 구성 매뉴얼
Configuring SANs with C-Series switches, iSCSI, and
multi-path access to EVA4000/6000/8000 storage in a
Windows environment
To configure iSCSI in a Windows environment that includes multi-pathing and EVA storage:
1.
"Install the Microsoft iSCSI
2. "Enable iSCSI on the C-Series
3. "Test
connectivity" on page 33
4. "Present iSCSI hosts as virtual Fibre Channel
5. "Zone the iSCSI Initiator and Fibre Channel storage
6. "Creating an iSCSI
7.
"Configuring p-Class Blade servers for
These procedures are described in the following sections. They enable you to quickly set up a basic
multi-path connection between a Windows iSCSI host and Fibre Channel storage .
Be sure to verify that your planned multi-path iSCSI solution conforms to the rules in the
system
constraints, page 30 section.
NOTE:
HP recommends using GbE NICs and IP switches in an iSCSI environment.
For advanced configuration parameters with CHAP, VRRP, or VSANs, see the appropriate Cisco
documentation and the iSCSI Initiator documentation. For more information about p-Class Blade server
setup and configuration, consult the p-Class Blade server documentation.
Figure 23 Multi-pathed iSCSI setup
Software constraints
The following are not supported:
•
HP Secure Path for MSA1000/1500, RA/MA8000, EMA/ESA12000, EVA3000/5000, VA, XP
•
HP Auto Path for XP/VA
30
Initiator" on page 31
switch" on page 31
host" on page 38
iSCSI" on page 42
hosts" on page 33
WWPNs" on page 36
Operating