Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼 - 페이지 2

{카테고리_이름} Cisco 9124 - mds multilayer fabric switch에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 9124 - mds multilayer fabric switch 36 페이지. Mds 9000 series
Cisco 9124 - mds multilayer fabric switch에 대해서도 마찬가지입니다: 사양 (2 페이지), 데이터시트 (9 페이지), 사양 (3 페이지), 구성 매뉴얼 (49 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (22 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (40 페이지), 매뉴얼 (16 페이지)

페이지 인쇄
Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼

Preinstallation

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. Use the statement number provided at
the end of each warning to locate its translation in the translated safety warnings that
accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Only trained and qualified personnel should be allowed to install, replace, or service
Warning
this equipment. Statement 1030
Each new switch requires a license; see the Cisco MDS 9000 Family NX-OS Licensing Guide for
Note
instructions on installing a license.
Preinstallation
This section includes the following information:
•
•
•
•
Installation Options
The Cisco MDS 9100 Series can be installed using the following methods:
•
•
Cisco MDS 9100 Series Hardware Installation Guide
2-2
Installation Options, page 2-2
Installation Guidelines, page 2-3
Required Equipment, page 2-4
Unpacking and Inspecting the Switch, page 2-4
In an open EIA rack, using:
The rack-mount kit shipped with the switch
–
The telco and EIA Shelf Bracket Kit (an optional kit, purchased separately) in addition to the
–
rack-mount kit shipped with the switch
In a perforated or solid-walled EIA cabinet, using:
The rack-mount kit shipped with the switch
–
The telco and EIA Shelf Bracket Kit (an optional kit, purchased separately) in addition to the
–
rack-mount kit shipped with the switch
Chapter 2
Installing the Cisco MDS 9100 Series
OL-21514-01