Cisco Aironet 1000 Series 배포 매뉴얼 - 페이지 31

{카테고리_이름} Cisco Aironet 1000 Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1000 Series 40 페이지. Install and upgrade internal modules and field replaceable units
Cisco Aironet 1000 Series에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 업그레이드 (28 페이지)

페이지 인쇄

Deployment

Determining How Many Access Points are Needed

In this section you define the coverage area for each floor in the building and divide it into rectangles

and calculate how many access points are needed by dividing the area of each rectangle by the Z factor

squared.

The example shown below is for a typical office building with a desired average user throughput of

5 Mbps.

Figure 5

Optional Minimal Site Survey

If the building type estimate needs to be verified, a quick minimal site survey can be done to verify the

signal strength of the access point for the coverage radius. For example, for a typical office building with

a desired average user performance of 12 Mbps a signal strength of -75 dBm or better is needed and the

site survey will be used to verify that the -75 dBm coverage radius of a Cisco 1000 Series lightweight

access point is 50 feet. Review the "Optional Minimal Site Survey" section of this document for how to

perform a site survey using a Cisco 1000 Series lightweight access point.

78-17279-01

Determining the Number of access points

150 ft.

APs (Area 2) = (450/77) x (150/77) = 12 APs

(Area 1)

150 ft.

(Area 2)

450 ft.

APs (Area 1) = (150/77) x (150/77) = 4 APs

Deployment Guide: Cisco Aironet 1000 Series Lightweight Access Points

Example Basic Guidelines Process

Total = 16 APs

150 ft.