Cisco AP776A - Nexus Converged Network Switch 5020 릴리스 노트 - 페이지 13

{카테고리_이름} Cisco AP776A - Nexus Converged Network Switch 5020에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AP776A - Nexus Converged Network Switch 5020 44 페이지. Cisco nexus 5000 series release notes release 4.1(3)n1(1) (ol-16601-01 h0, july 2009)
Cisco AP776A - Nexus Converged Network Switch 5020에 대해서도 마찬가지입니다: 릴리스 노트 (48 페이지), 릴리스 노트 (26 페이지), 릴리스 노트 (22 페이지), 빠른 참조 매뉴얼 (14 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (26 페이지)

페이지 인쇄
Cisco AP776A - Nexus Converged Network Switch 5020 릴리스 노트
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing Fabric Manager on Windows
This section describes how to install Fabric Manager on Windows.
Note
Fabric Manager Server can not be installed on an Active Directory Server when using PostgreSQL,
Fabric Manager servers are domain controllers and can not create local PostgreSQL user accounts.
If your server is running Terminal Services in Application mode, or if you are running Citrix Metaframe
or any variation thereof, you need to issue the following command on the DOS prompt before installing
Fabric Manager Server.
1.
2.
Note
3.
4.
To install Fabric Manager on Windows, follow these steps:
Click the Install Management Software link.
Step 1
Choose Management Software > Cisco Fabric Manager.
Step 2
Click the Installing Fabric Manager link.
Step 3
Select the drive for your CD-ROM.
Step 4
Click the FM Installer link.
Step 5
Follow the onscreen instructions provided in the Fabric Manager Installer 3.3(3).
Step 6
To install Device Manager on your workstation, follow these steps:
Enter the IP address of the switch in the Address field of your browser.
Step 1
Click the Cisco Device Manager link in the Device Manager installation window.
Step 2
Step 3
Click Next to begin the installation.
OL-14116-11
Open a command-line prompt: Start > Run, then type cmd and press Return.
At the command prompt type: user /install.
Do not close the command line window. This must remain open for the entire duration of the
install.
The following is an example of the output of this command:
C:\Documents and Settings\user.domain>USER /INSTALL
User session is ready to install applications.
Follow all steps needed to install Fabric Manager, Fabric Manager Server, and Device Manager. See
the instructions later in this section.
When the installation is complete, at the command prompt, type user /execute and press Return.
Then type exit and press Return.
The following is an example of the output of this command:
C:\Documents and Settings\user.domain>USER /execute
User session is ready to execute applications.
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(3)
Upgrading Your Cisco MDS SAN-OS Software Image
13