Cisco AP776A - Nexus Converged Network Switch 5020 릴리스 노트 - 페이지 12

{카테고리_이름} Cisco AP776A - Nexus Converged Network Switch 5020에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AP776A - Nexus Converged Network Switch 5020 26 페이지. Cisco nexus 5000 series release notes release 4.1(3)n1(1) (ol-16601-01 h0, july 2009)
Cisco AP776A - Nexus Converged Network Switch 5020에 대해서도 마찬가지입니다: 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (22 페이지), 빠른 참조 매뉴얼 (14 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (26 페이지)

페이지 인쇄
Cisco AP776A - Nexus Converged Network Switch 5020 릴리스 노트

Caveats

S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m
Caveats
This section includes the following topics:
•
•
•
•
•
•
•

Open Caveats

This section lists the open caveats for this release.
•
•
•
•
•
Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1a)
12
Open Caveats, page 12
CSCsy53718
Symptom: If errdisable recovery interval is configured to the maximum value of 65535 (taking
approximately 18hrs), when a port is errdisabled due to a recovery enabled cause, it takes four more
hours for the recovery to take effect.
Workaround: None.
CSCsy05103
Symptom: When an RBAC role is configured to deny a few commands within a specific interface,
the help command falsely displays all commands as denied. This is only a help issue and the rules
are enforced as configured.
Workaround: None.
CSCsy16212
Symptom: When an RBAC role is configured to deny a few commands, users within that role may
incorrectly see a some disallowed commands in the help. This is only a help issue and commands
are denied as per the configured rules.
Workaround: None
CSCsy28374
Symptom: An RBAC role with rules denying commands for all interfaces of certain types using the
wildcard * option, are not honored.
Workaround: Configure rules with specific interface names.
CSCsv81694
Symptom: The auto learn static MAC entry is removed if the port on which the same MAC address
is dynamically learned is flapped. The static MAC address is removed from the software as well as
the hardware.
Workaround: Re-add the static MAC entry through the CLI.
OL-16601-01