Cisco ASR 900 Series 구성 매뉴얼 - 페이지 7

{카테고리_이름} Cisco ASR 900 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 900 Series 13 페이지. Configuring 1g traffic on 8-port 10 gigabit ethernet interface module
Cisco ASR 900 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 구성 매뉴얼 (6 페이지), 구성 매뉴얼 (6 페이지)

페이지 인쇄

autonomic control planes that can be created based on the different capabilities of the devices. The autonomic control plane is

established by using the following mechanisms:

• Configuring a loopback interface.

• Dynamically assigning an IPv6 address to the loopback interface.

• Configuring an autonomic VPN routing and forwarding (VRF).

How to Configure Autonomic Networking

Configuring the Registrar

Procedure

Command or Action

Step 1

enable

Example:

Device> enable

Step 2

configure terminal

Example:

Device# configure terminal

Step 3

autonomic connect

Example:

Device(config)# autonomic connect

Step 4

autonomic registrar

Example:

Device(config)# autonomic registrar

Step 5

domain-id domain-name

Example:

Device(config-anra)# domain-id abc.com

Step 6

device-accept "udi"

Example:

Device(config-anra)# device-accept

"PID:A901-12C-FT-D SN:CAT1902U88Y"

Purpose

Enables privileged EXEC mode.

• Enter your password if prompted.

Enters global configuration mode.

(Optional) Connects a nonautonomic management device, such as

an authentication, authorization, and accounting (AAA) server, or a

syslog server, to the autonomic network.

Enables a device as a registrar and enters registrar configuration

mode.

Represents a common group of all devices registering with the

registrar.

(Optional) Specifies the Unique Device Identifier (UDI) of a

quarantined device to be accepted in the autonomic domain.

• udi—Must be entered in double quotes to ensure that spaces

and special characters are inclusive in the argument.

Note

This command is not required when configuring the

registrar. It is required only after the registrar is enabled to

accept previously quarantined devices.