Cisco ASR 920 series 설치 매뉴얼 - 페이지 2
{카테고리_이름} Cisco ASR 920 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 920 series 42 페이지. Aggregation services router
Cisco ASR 920 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 시작하기 (6 페이지), 하드웨어 설치 매뉴얼 (46 페이지), 매뉴얼 (36 페이지)
페이지 인쇄
Installing the Router in a Rack
Installing the Router in a Rack
The following sections describe how to install the Cisco ASR 920 Series Router in a rack. The procedures in
this section apply to both horizontal and vertical mounting of the router in a rack:
Installing the Chassis Brackets
The chassis is shipped with mounting brackets that can be installed on the front or rear of the chassis. To
install the brackets on the front of the chassis, perform these steps:
SUMMARY STEPS
1. Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
2. Position one of the brackets against the chassis side, and align the screw holes.
3. Secure the bracket to the chassis with the screws removed when performing Step 1 . The recommended
maximum torque is 10 in.-lb.
4. Repeat Step 2 and Step 3 for the other bracket.
DETAILED STEPS
Step 1
Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
The figure below shows how to attach the brackets at the front, middle, and rear positions on the Cisco ASR 920 Series
Router for a 19-inch EIA rack.
Figure 1: Attaching Mounting Brackets for a 19-inch EIA Rack (Front, Middle, and Rear Positions)
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
2
Installing the Cisco ASR 920 Series Router