Cisco BTS 10200 사용자 설명서 - 페이지 25

{카테고리_이름} Cisco BTS 10200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco BTS 10200 35 페이지. Softswitch

Table 1

From (Unit, Port)

PDU-B-8

HUB-A Ground

HUB-B Ground

CA-A Ground

CA-B Ground

EMS-A Ground

EMS-B Ground

Alarm Panel Ground

1. The ports shown are applicable to 100 Mb Ethernet uplinks. Cable No. for uplink connections are

customer-defined. See the procedure for more information. If you need to connect gigabit Ethernet instead of

100Mb Ethernet, contact Cisco TAC for assistance.

2. To (Unit, Port) and Cable No. for SS7 signaling (T1) connections are customer-defined. In some networks, SS7

cables do not need to be connected to the Cisco BTS 10200 Softswitch. See the procedure for more

information.

3. The CONSOLE cables are specially designed for Cisco 2924M Ethernet Switch CONSOLE port access. Make

sure that you are using the correct cables. One end of the CONSOLE cable is labeled "switch" and the other is

labeled "net CCN". The "switch" end must connect to the Hub and the "net CCN" end must connect to the

Alarm Panel.

4. There are two cables labeled #58. Connect both cables as specified in this table.

OL-2906-01

C I S C O C O N F I D E N T I A L

Cable List (See Procedure for Descriptions and Drawings) (continued)

To (Unit, Port)

ALARM PANEL-B

PDU Ground

Cable No.

#58

Appendix B: Cable List