Cisco BTS 10200 사용자 설명서 - 페이지 5

{카테고리_이름} Cisco BTS 10200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco BTS 10200 35 페이지. Softswitch

Figure 3

Obtain the 18 Ethernet cables needed for connections between the rear panel of the Call Agents (CA A

Step 3

and CA B) and the two Cisco 2924M Ethernet Switches (Hub A and Hub B). These cables are listed in

Table 1

Step 4

Connect the 18 Ethernet cables to the ports on the rear panel of the CA units as listed in

Appendix B: Cable List, page

Figure 4

Connect CONSOLE Ethernet Cables to Alarm Panel

Connect the two CONSOLE Ethernet cables from the Alarm Panel to the Hubs as described in this

section.

OL-2906-01

C I S C O C O N F I D E N T I A L

Partial Rear View of the EMS Unit Showing Ethernet Ports

EMS (AXi)

Appendix B: Cable List, page

23.

shows the rear view of the CA. On the CA, use ports ETH0 and ZNB0 through ZNB7.

Partial Rear View of the CA Unit Showing Ethernet Ports

Call agent (AXmp)

Connect CONSOLE Ethernet Cables to Alarm Panel

23.

Table 1