Cisco BTS 10200 Softswitch 사용자 설명서 - 페이지 8

{카테고리_이름} Cisco BTS 10200 Softswitch에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco BTS 10200 Softswitch 29 페이지. T.38 fax relay

페이지 인쇄

External Interfaces

Table 2

Measurement Name

FAX_PAGES_SENT

FAX_PAGES_RECV

Provisioning

This section describes provisioning changes that resulted from the addition of the T.38 Fax Relay feature

to the Cisco BTS 10200 Softswitch software. For more information on provisioning commands, refer to

the

H323_GW—This table defines the capabilities of each H.323 protocol gateway. The parameters added

for T.38 fax relay include:

•

H323_TRUNK_GRP_PROFILE—This table is responsible for providing information that is used on

a per-call basis for any H.323 trunk group. The parameters added for T.38 fax relay include:

•

MGW_PROFILE—This table provides templates for defining a Media Gateway by hardware vendor.

It identifies the specifications and settings necessary for communications between the Call Agent and

each type of Media Gateway. The parameters added for T.38 fax relay include:

•

Cisco BTS 10200 Softswitch T.38 Fax Relay Support

T.38 Fax Relay Traffic Counters

"Command Reference" section on page

FAX-RELAY-CAP—the T38 fax relay option for this gateway. The value is one of the following:

T38_CA_FAX—CA-controlled fax mode. This is the default value.

–

INBAND—Inband fax mode.

–

FAX_T38_CAMODE_SUPP—if set to "Y." CA-controlled mode is supported for T38 fax relay

FAX_INBAND_SUPP—if set to "Y," the inband mode is supported for T38 fax relay

FAX_PREF_MODE—this is the preferred mode for T38 fax relay. The value is one of the following:

FAX_T38_CAMODE—CA-controlled mode is the preferred mode (This is the default value.)

–

FAX_INBAND—Inband mode is the preferred mode

–

FAX_T38_CAMODE_SUPP—if set to "Y" (the default value), the CA-controlled mode is

supported for T38 fax relay

FAX_INBAND_SUPP—if set to "Y" (the default value), the inband mode is supported for

T38 fax relay

FAX_PREF_MODE—this is the preferred mode for T38 fax relay. The value is one of the following:

FAX_T38_CAMODE—CA-controlled mode is the preferred mode (This is the default value.)

–

FAX_INBAND—Inband mode is the preferred mode

–

Cisco BTS 10200 Softswitch T.38 Fax Relay

Measurement Description

Number of fax pages sent.

Number of fax pages received.

13.