BYOC BA6110 사용 설명서 - 페이지 10

{카테고리_이름} BYOC BA6110에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BYOC BA6110 14 페이지.

Step 14: Add the 1/4 jacks. Both are stereo, so it makes no difference which is in or

out . MAKE SURE YOU SOLDER THEM TO THE UNDERSIDE OF THE BOARD!!!!

Step 15: DO NOT SOLDER!!!!!!!!!!!!!!!!!!!!!!Only insert the LED into it's place on the

underside of the circuit board but do not solder it. This time the negative lead goes in the

square solder pad. It will be the side that is flat. The positive lead goes inthe round hole and

will be the longer lead. Bend the leads on the top side so that the LED does not fall out.

After you test the pedal and you are certain that it works, then you will position the LED into

the hole in the enclosure and solder it. Once you solder it, it's very difficult to get the LED

back in the enclosure hole if you take the board out to trouble shoot.