Accustic Arts MONO III MK2 매뉴얼 - 페이지 8

{카테고리_이름} Accustic Arts MONO III MK2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Accustic Arts MONO III MK2 13 페이지.

Fig. 5: This simplified diagram serves to illustrate damping factor linearization

4. 3 Mute function

Fig. 6: Positions of the MUTE switch

When the switch MUTE is pressed, the speaker outputs of the unit are turned off. The blue

LED is still illuminated, but the speakers get no signal.

Releasing the switch MUTE activates the speaker outputs.

The switch MUTE is designed for very short listening interruptions, to keep the unit on perfect temperature (=

optimized sound). If you're not going listen music for a longer time (e.g. more than 1 hour), please always switch

off the unit completely by pressing the main power switch 13on the front.

IMPORTANT!

Please use the MUTE function when connecting speaker cables. It prevents short

circuits.

4. 4 Loudspeaker cables and correct phase for the loudspeakers

For each channel the power amplifier has 2 pairs of WBT loudspeaker terminals labelled A and B. With this

arrangement you can wire your loudspeaker system in a BI-WIRING mode. If you want to control your

loudspeakers with only one cable you can either use pair A or pair B. Both connections are identical and therefore

have exactly the same characteristics.

Please use only high-quality loudspeaker cables. This is the only way to ensure that the sound quality of the power

amplifier is fully exploited.

To connect the cables to the power amplifier or loudspeakers if possible, use high quality terminal ends or banana

plugs

and avoid connecting bare litz wires (except: OFC-cables) since these corrode and so restrict the signal flow.

The terminals on your power amplifier and your loudspeaker are colour coded or marked with a plus (+) and minus

(-). Connect the red (+) output terminal of your amplifier with the red (+) input terminal of your loudspeaker. Proceed

in the same way with the white or black (-) terminals.