Cisco C-series Nexus 5020 하드웨어 설치 매뉴얼 - 페이지 14
{카테고리_이름} Cisco C-series Nexus 5020에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco C-series Nexus 5020 19 페이지. Replacing an i/o module nexus 5000 series
Cisco C-series Nexus 5020에 대해서도 마찬가지입니다: 사양 (3 페이지), 데이터시트 (23 페이지), 릴리스 노트 (26 페이지), 릴리스 노트 (3 페이지), 매뉴얼 (11 페이지)
페이지 인쇄
Replacing a Fan Module
Modules with port-side intake airflow have a black stripe and modules with port-side intake airflow do
Note
not have a colored stripe.
This section includes the following topics:
•
•
Removing a Fan Module
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
Warning
fan blades completely stop before you remove the fan tray. Statement 258
Caution
Before you remove a fan module, ensure that the module that you are going to install in the open slot has
the same direction of airflow as the module that you are removing to avoid over heating the switch and
causing it to shutdown. If the module that you are removing has a black stripe for back-to-front airflow,
the new module must also have a black stripe. If the module that you are removing does not have a black
stripe, then the new module must also not have a black stripe.
To remove a fan module, follow these steps:
Loosen the captive screws on the fan module by turning them counterclockwise, using a flat-blade or
Step 1
number 2 Phillips screwdriver if required.
Grasp the handle of fan module and pull it outward.
Step 2
Pull the fan module clear of the chassis.
Step 3
Installing a Fan Module
Before installing the new fan module, ensure that the module is marked for the same direction of airflow
Caution
as all of the other modules installed in the switch. If the installed modules have a black stripe for
back-to-front airflow, then the new module you are installing must have a black stripe. If the installed
modules do not have a black stripe (front-to-back airflow), then the module that you are installing must
also not have a black stripe. If all of the modules are not taking in cold air from the cold aisle, the switch
can overheat and shutdown.
To install a fan module, follow these steps:
Hold the fan module with the LED at the bottom (Cisco Nexus 5596 or Cisco Nexus 5020) or right (Cisco
Step 1
Nexus 5548 or Cisco Nexus 5010).
Cisco Nexus 5000 Series Hardware Installation Guide
4-14
Removing a Fan Module, page 4-14
Installing a Fan Module, page 4-14
Chapter 4
Replacing Components