BYOC Tremelo 사용 설명서 - 페이지 13

{카테고리_이름} BYOC Tremelo에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BYOC Tremelo 16 페이지.

swap the R3 and R1 wires so that lug1 of the rate pot is connected to R3 and lug 3 of the

Installing the LED and Mounting the Circuit

You will install the LED at the same time you mount the circuit board.

1. Insert the LED into its slot on the underside or solder side of the circuit board,but DO NOT

SOLDER it yet. Make sure the anode(the long leg) goes in the round solder pad and the cathode(the

short leg)goes in the square solder pad. No. This is not a typo. Yes. This is contradictory to the way

most polarized components go in the circuit board.

2. Once you have the LED in place, bend the leads a little bit so that it will not fall out when you turn the

PCB over.

3. Install the nylon circuit board standoffs into the mounting holes.

4. Remove the paper backings on the standoff to expose the self-adhesive tape.

5. Insert the LED bulb into the LED hole in the enclosure.

6. Secure the Standoffs to the back of the potentiometers.

7. Your LED should still be free to move up and down slightly. You probably do not want your LED

sticking all the way out of the hole. So pull up on the LED legs till you have it properly positioned and

rate pot is connected to R1.

Board