Cisco C3850-NM-4-1G 설치 - 페이지 15

{카테고리_이름} Cisco C3850-NM-4-1G에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco C3850-NM-4-1G 17 페이지.
Cisco C3850-NM-4-1G에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지)

Installing a Network Module

Procedure

Step 1

Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface.

Step 2

Find the send (TX) and receive (RX) markings that identify the top of the SFP module.

On some SFP modules, the send and receive (TX and RX) markings might be shown by arrows that show the

direction of the connection.

Step 3

If the SFP module has a bale-clasp latch, move it to the open, unlocked position.

Step 4

Align the module in front of the slot opening, and push until you feel the connector snap into place.

Figure 9: Installing an SFP Module in the Network Module

Step 5

If the module has a bale-clasp latch, close it to lock the SFP module in place.

Step 6

Remove the SFP dust plugs and save.

Step 7

Connect the SFP cables.

Figure 10: Network Module with SFP Modules Installed

OL-26779-05

Installing SFP and SFP+ Modules

Catalyst 3850 Switch Hardware Installation Guide