AccuStream A2 Cutting Head 매뉴얼 - 페이지 11

{카테고리_이름} AccuStream A2 Cutting Head에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuStream A2 Cutting Head 20 페이지.

AccuStream Cutting Systems

4.4 Actuator Maintenance

The actuator is not a regularly serviced item. It is recommended, that the

actuator be disassembled annually. The actuator should be thoroughly

cleaned and all the internal parts inspected for wear.

If the actuator does not appear to be functioning properly, first check the

actuator for air leaks. There should never be air leaking from the bottom

area of the actuator. With the jet on there should be no air leaking from

the exhaust vent. Air leaks indicate that o-rings need to be replaced.

Over time, abrasives can accumulate inside the housing. The o-rings, will

show wear and the springs may lose some of their force. Replace all worn

parts: springs, exhaust vent, piston seal and o-rings.

1. Remove the air fitting from the top of the

actuator.

2. Remove the Retainer cap from the bottom of the

actuator.

3. Place the actuator in a large vise and tighten the

vise just enough to apply slight compression to

the actuator springs.

4. Use a locking type snap ring pliers to close

(compress) the retaining ring that secures the

Actuator Cap into the Housing.

5. Carefully open the vise while verifying that the

Cap is coming free from the Housing.

NOTE: The actuator contains high force springs

and should be serviced with caution!

13084 ON/OFF VALVE & CUTTING HEAD MANUAL

Valve in vise

Snap-ring removed