AccuStream A2 Cutting Head 매뉴얼 - 페이지 8

{카테고리_이름} AccuStream A2 Cutting Head에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuStream A2 Cutting Head 20 페이지.

AccuStream Cutting Systems

4.2 Mounting Collar

The AccuValve is normally mounted with the mounting collar assembly 11198 (shown below) using the

¼" HP inlet connection. The Thimble Filter comes standard with the Dialine assembly. This filter can

be purchased separately. Other mounting options are also available.

1. To install the mounting collar, transfer, drill and tap two 5/16-18UNC holes into the Z-axis

faceplate.

NOTE: For proper alignment, the mounting holes must be 1.625 in. (41.275 mm) from center

of holes apart. See illustration (above).

2. With the adapter and seat removed from the valve body, slide the valve body down into the

collar and align the high-pressure water inlet hole with the collar.

13084 ON/OFF VALVE & CUTTING HEAD MANUAL