Cisco Catalyst 2900 Series 하드웨어 설치 매뉴얼 - 페이지 30

{카테고리_이름} Cisco Catalyst 2900 Series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2900 Series 47 페이지. Xl modules
Cisco Catalyst 2900 Series에 대해서도 마찬가지입니다: 매뉴얼 (19 페이지)

페이지 인쇄

Connecting to Module Ports

Note

Figure 2-5

Inserting an SC Connector into a 100BaseFX or 1000BaseX SC Module

Using a Patch Cord with the GBICs

Note

Catalyst 2900 Series XL Modules Hardware Installation Guide

2-8

Always use a straight-through cable when connecting to a PC,

server, or workstation. Use a crossover cable to connect to another

switch or hub. See the section "10/100 Module Cabling" in

Appendix B, "Connectors and Cables."

Tighten

Screws

To Activate

WS-X29 31-XL

10BaseT /100Base Tx

When using the LX/LH GBIC with 62.5-micron diameter multimode fiber

(MMF), you must install a mode-conditioning patch cord (Cisco product number

CAB-GELX-625 or equivalent) between the GBIC and the MMF cable on both

the transmit and receive ends of the link for link distances greater than 984 feet

(300 meters).

You must use the patch cord to comply with the IEEE 802.3z

standards. Using the LX/LH GBIC with MMF and no patch cord for

very short link distances (tens of meters) is not recommended. The

result could be an elevated bit error rate (BER).

Tighten

Screws

To Activate

100Ba seFX

WS-X29 22-XL-V

Chapter 2

Installation

SERIES

78-5912-03