BYOGuitar.com JEM 조립 지침 매뉴얼 - 페이지 5

{카테고리_이름} BYOGuitar.com JEM에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BYOGuitar.com JEM 11 페이지.

Installing the Bolt on Neck

Most o f the kits come with the holes pre-drilled. If they are pre-drilled on your kit you can skip to

section "Attaching the Neck to the Body". Below are the instruction if you need to drill them.

Unless otherwise indicated, we strongly recommend using a drill press for the majority of drilling to

obtain the most precise results. However, an electric/cordless drill fitted with a depth stop or a drill

stand can be used if you do not have a drill press.

If the mounting holes have been pre-drilled, skip to the next section.

1. Use the neck plate as a template to locate the mounting holes in the neck pocket.

The simplest way is to place the neck plate into the pocket and properly position it so it

is centered in the pocket.

2. Mark the holes

3. Center punch your marks.

4. Drill the holes using a 3/16" drill bit.

You should be able to fit the neck in the neck pocket by hand.

Place the neck in the pocket.

a. Make sure the neck is aligned properly with the pickup cavities and bridge.

b. Clamp the neck in place.

2. Use the same drill bit you drilled the holes in the body with to center punch the locations on the

neck.

a. Place the bit in the hole through the body and tap it a few times to make a mark on the

neck.

3. Remove the neck from the body.

4. Determine the neck mounting hole depth.

a. Place one of the neck mounting screws through the neck plate and body into the neck

pocket.

Measure the amount of the mounting screw that extends up into the neck pocket, and

mark your drill bit (a piece of masking tape around the bit works great).

c. Double check the depth by holding the marked drill bit to the side of the neck and be

certain the drill won't go through the fingerboard.

5. Drill the holes in the neck with a 1/8" drill bit. Make sure you don't drill through the

fingerboard!