Digiscan Labs iPROTECT 1216 매뉴얼 - 페이지 7

{카테고리_이름} Digiscan Labs iPROTECT 1216에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digiscan Labs iPROTECT 1216 13 페이지. Counter surveillance 3-band rf detector

Antennas

To achieve the best performance the iProtect 1216 uses 2 antennas. Bands 1 and 2 receive the signal

from the SMA connector, while the 3rd band uses the rigidly attached microwave antenna.

Thanks to its compact size and relatively smooth frequency coverage the standard rod antenna from

the supplied set is well suited for most detection tasks. It can be used both in the ALL BANDS and

ONE BAND display modes.

Employing other antennas may increase sensitivity and detection distance on specific bands in

accordance with the antenna's specifications.

The following optional antennas can be recommended (not included in the supplied set):

Omnidirectional antenna ODA-4 - increases sensitivity on BAND 1

Directed antenna MWA-6 – increases sensitivity and adds directivity on BAND 2

Status display

The iProtect 1216 has the second display showing the auxiliary information:

ALARM – threshold exceeded

3G, GSM, BT_WF, DECT Idle, DECT Active - signatures

Display mode:

ALL BANDS or

ONE BAND

USAGE

Warning

To avoid false detections it is very important to deactivate all radio-transmitting devices

in the area before using the iProtect 1216:

All Wi-Fi access points and Wi-Fi devices (printers, surveillance cameras, laptops, pods, etc.)

Cell phones

Cordless phones

Bluetooth devices, etc.

Battery status:

OK – fully charged

MED. – charged 30-80%

LOW. – less than 30% left