Digiscan Labs Protect 1207i 사용자 설명서 - 페이지 5

{카테고리_이름} Digiscan Labs Protect 1207i에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digiscan Labs Protect 1207i 12 페이지.

Bargraphs

The Protect 1207i has 6, 10-segment, 'SIGNAL STRENGTH' bar graph

indicators providing the following precise information to the operator:

The closer the unit is to the source of transmission the higher the bar graph

level will be. Some powerful sources may cause full illumination of the display

(this also happens when the unit is in close proximity to a transmitter). In such

cases use the attenuator function (ATT+/ATT- buttons) to alter the sensitivity.

It is also recommended to use the attenuator when there are many back-

ground noises in the area which can create difficulties before a search. Please

note: The vibration function will turn on when the SIGNAL STRENGTH of any

of the bar graph indicators approaches the level selected in the setup mode.

CDMA/LTE800 (4G) standard

GSM 900 standard

GSM 1800

WCDMA (UMTS, 3G), most of

the modern DECT telephones

or as above plus GSM 1900

and CDMA 1900

Wi-Fi access points and

adapters, Bluetooth devices

All transmitters in the range

of 2.5-6GHz, including most

kinds of the Wi-Max/Wi-Fi

High/LTE (4G) protocols