Crestron FlipTop FT-TS600 사용자 설명서 - 페이지 2

{카테고리_이름} Crestron FlipTop FT-TS600에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron FlipTop FT-TS600 2 페이지.
Crestron FlipTop FT-TS600에 대해서도 마찬가지입니다: 보충 설명서 (16 페이지)

페이지 인쇄

Connect the Device

Make the necessary connections as called out in the illstration

that follows.

When making connections to the FT-TS600, note the

following:

• Use Crestron power supplies for Crestron equipment.

• The included cable cannot be extended.

LAN PoE:

AUD OUT:

10BASE-T / 100BASE-TX

To Balanced

Ethernet to LAN

Line Level Input

COMPUTER:

Ground

To PC

CAUTION:

Do not apply excessive pressure to the touch

screen display during handling. Doing so can crack the screen

and damage the device.

NOTE:

Ensure the unit is properly grounded by connecting

the chassis ground lug to an eargh ground (building steel).

As of the date of manufacture, the product has been tested and found to comply with specifications for CE marking.

This product is Listed to applicable UL Standards and requirements by Underwriters Laboratories, Inc.

Federal Communications Commission (FCC) Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

Caution: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's

authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

GUIDE

Access the Setup Screens

NOTE:

The FT-TS600 can take up to 45 seconds to boot.

NOTE:

If no project has been loaded or if an invalid project

has been loaded, the screen displays the following message:

"There is no display project to start. [Touch Screen to Enter

Setup...]."

The setup screens enable basic configuration prior to regular

operation of the FT-TS600.

During regular operation of the touch screen, there are two

ways to access the setup screens:

1. Place a button on the project main page and assign the

reserved join number (17242) that accesses the setup

screens.

2. Press hard keys 1, 2, 3, and 4 on the right side of the

touch screen display in sequence twice (press 1, 2, 3, 4,

1, 2, 3, 4) within a 5 second period.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Industry Canada (IC) Compliance Statement

CAN ICES-3(B)/NMB-3(B)

Crestron product development software is licensed to Crestron dealers and Crestron Service Providers (CSPs) under a limited non-exclusive, non-transferable Software Development Tools

License Agreement. Crestron product operating system software is licensed to Crestron dealers, CSPs, and end-users under a separate End-User License Agreement. Both of these Agreements

can be found on the Crestron website at www.crestron.com/legal/software_license_agreement.

The specific patents that cover Crestron products are listed at patents.crestron.com.

Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. UL and the UL logo are either trademarks

or registered trademarks of Underwriters Laboratories, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this document

to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for

errors in typography or photography.

This document was written by the Technical Publications department at Crestron.

Learn More

Visit the website for additional information

and the latest firmware updates.

Crestron Electronics

15 Volvo Drive, Rockleigh, NJ 07647

888.CRESTRON | www.crestron.com

The product warranty can be found at www.crestron.com/warranty.

DOC. 7784A (2043774) 04.15

Specifications subject to change without notice.