Digiscan Labs DNG-2300 사용자 설명서 - 페이지 6

{카테고리_이름} Digiscan Labs DNG-2300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digiscan Labs DNG-2300 11 페이지.

Plastic Disk Mounting

The transducer may be attached to plate glass windows or other smooth surfaces using the plastic-

mounting disk. The glass must be firmly mounted to avoid vibration.

la. For temporary mounting, use double-stick tape and press the disk firmly to the clean and dry

surface. (Figure 5)

1b. For permanent mounting, discard the double-stick tape and use a small amount of clear silicone

exterior caulking compound. Place a small thin layer across the disk and press firmly and evenly to

minimize air bubbles. This method provides better coupling for high frequency response. Allow the

adhesive to set as recommend by the manufacturer (usually 24 hours). (figure 6A)

Screw the Transducer clockwise onto the plastic disc until firm. DO NOT TIGHTEN

EXCESSIVELY. (figure 6B)

Attention: Be sure not to over tighten the transducer, the plastic insert may be damaged

Figure 4

Figure 5

Figure 6