Cisco Catalyst 2960-L 설치 매뉴얼 - 페이지 5

{카테고리_이름} Cisco Catalyst 2960-L에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-L 22 페이지.
Cisco Catalyst 2960-L에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (20 페이지)

페이지 인쇄

1. Installation Guidelines

Switch Installation

Tools and Equipment

Obtain these necessary tools:

• A Number-2 Phillips screwdriver to rack-mount the switch

Installation Guidelines

When determining where to install the switch, verify that these guidelines are met:

• Clearance to the switch front and rear panel meets these conditions:

• Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting

• Airflow around the switch and through the vents is unrestricted.

• Temperature around the unit does not exceed 113°F (45°C). If the switch is installed in a closed or

• Humidity around the switch does not exceed 90 percent.

• Altitude at the installation site is not greater than 10,000 feet.

• For 10/100/1000 fixed ports, the cable length from a switch to a connected device cannot exceed 328

AC power cord

Four rubber-mounting feet (51-0089)

Compliance documentation

(78-100866-01)

Two 19-inch mounting brackets

Cable guide

Four Number-12 Phillips pan-head screws

(48-0523-01)

• Front-panel LEDs can be easily read.

• Access to ports is sufficient for unrestricted cabling.

• AC power cord can reach from the AC power outlet to the connector on the switch rear panel.

fixtures. Make sure that the cabling is safely away from other devices that might damage the cables.

multirack assembly, the temperature around it might be greater than normal room temperature.

feet (100 meters).

Four Number-8 Phillips flat-head screws

(48-2927-01)

One black Phillips machine screw

(48-0654-01)

(Optional) Console cable or USB cable

(Optional) Power cord retainer

Icon legend label (47-103380-01 for 1G

SFP modules and 47-103993-01 for 10G

SFP+ modules.)

Switch Installation

Tools and Equipment