DigiSender Plug'n'Go LCD 사용자 설명서 - 페이지 6
{카테고리_이름} DigiSender Plug'n'Go LCD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiSender Plug'n'Go LCD 16 페이지. 5.8ghz single input ‘plug style’ wireless av sender
페이지 인쇄DX2000-LCD - DigiSender® Plug'n'Go™ LCD
Step 3: Install the Receiver
The DX2000-LCD Receiver will pick up the signals being sent by your DX2000-LCD Transmitter and out-
put them to a connected TV.
1.
Locate a vacant SCART socket on the back of your
receiving TV and insert the DigiSender® SCART
cable.
3.
Press and hold the power button for 5 seconds to
turn the Receiver on. Pressing the button again
cycles through the 4 available channels. Make sure
it is set to channel 1.
Page 06
2.
Connect the Receiver into a Mains Extension
Lead. The positioning of the Receiver can affect
the picture quality so being able to move it is an
advantage.
4.
Position the IR Sensor on the top, side or bot-
tom of your receiving TV with the lens facing
out into the room.
Please read this instruction manual carefully prior to installation