Cisco Catalyst 2960-S Series 시작 설명서 - 페이지 28
{카테고리_이름} Cisco Catalyst 2960-S Series에 대한 시작 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-S Series 31 페이지. Switch getting
Cisco Catalyst 2960-S Series에 대해서도 마찬가지입니다: 데이터시트 (28 페이지), 설치 매뉴얼 (27 페이지)
페이지 인쇄
Resetting the Switch
Caution
Accessing Help Online
Catalyst 2960-S Switch Getting Started Guide
28
Follow these steps to return your switch to the factory default settings. These are
reasons why you might want to reset the switch:
You installed the switch in your network and cannot connect to it because you
•
assigned the wrong IP address.
You want to clear all configurations from the switch and assign a new IP
•
address.
You want to reset the password on the switch.
•
Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
Press and hold the Mode button. The switch LEDs begin blinking after about
3 seconds. Continue holding down the Mode button. The LEDs stop blinking after
7 more seconds, and then the switch reboots.
The switch now behaves like an unconfigured switch. You can enter the switch IP
information by using Express Setup as described in the
section on page
4.
First look for a solution to your problem in the troubleshooting section of the
switch hardware installation guide or the switch software configuration guide on
Cisco.com. You can also access the Cisco Technical Support and Documentation
website for a list of known hardware problems and extensive troubleshooting
documentation.
Catalyst 2960-S Switch Getting Started Guide
"Running Express Setup"
OL-19793-02