Cisco Catalyst 2960-S Series 설치 매뉴얼 - 페이지 22

{카테고리_이름} Cisco Catalyst 2960-S Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-S Series 27 페이지. Switch getting
Cisco Catalyst 2960-S Series에 대해서도 마찬가지입니다: 데이터시트 (28 페이지), 시작 설명서 (31 페이지)

페이지 인쇄

1. Switch Installation

Connecting to SFP and SFP+ Modules

Insert a dust plug into the optical ports of the SFP or SFP+ module to keep the optical interfaces clean.

Step 3

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the latch is

Step 4

obstructed and you cannot use your finger, use a small, flat-blade screwdriver or other long, narrow

instrument to open the latch.

Step 5

Grasp the SFP or SFP+ module, and carefully remove it from the module slot.

Step 6

Place the module in an antistatic bag or other protective environment.

Connecting to SFP and SFP+ Modules

For instructions on how to connect to fiber-optic SFP modules, see the

and SFP+ Modules"

see the

For instructions about how to install or remove an SFP module, see the

Modules" section on page

Connecting to Fiber-Optic SFP and SFP+ Modules

Warning

Class 1 laser product. Statement 1008

Do not remove the rubber plugs from the SFP or SFP+ module port or the rubber caps from the

Caution

fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module

ports and cables from contamination and ambient light.

Before connecting to the SFP module, be sure that you understand the port and cabling stipulations in

the

page

SFP module.

Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.

Step 1

Step 2

Insert one end of the fiber-optic cable into the SFP or SFP+ module port (see

Catalyst 2960-S Switch Hardware Installation Guide

1-22

section. For instructions on how to connect to copper 1000BASE-T SFP modules,

"Connecting to 1000BASE-T SFP"

1-20.

"Installation Guidelines" section on page 1-4

1-8. See

Appendix 1, "Connector and Cable Specifications"

section.

and in the

"SFP and SFP+ Module Slots" section on

for information about the LC on the

Chapter 1

Switch Installation

"Connecting to Fiber-Optic SFP

"Installing SFP and SFP+

Figure

1-24).

OL-19732-04