Cisco Catalyst 2960-X 하드웨어 설치 매뉴얼 - 페이지 34
{카테고리_이름} Cisco Catalyst 2960-X에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-X 34 페이지.
Cisco Catalyst 2960-X에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (25 페이지), 하드웨어 매뉴얼 (20 페이지)
페이지 인쇄
Where to Go Next
Device
Switch to computer or server
Switch to router
Switch to IP phone
1 100BASE-TX and 1000BASE-T traffic requires twisted four-pair, Category 5 or higher. 10BASE-T traffic can use Category 3 cable or higher.
Where to Go Next
If the default configuration is satisfactory, the switch does not need further configuration. You can use any
of these management options to change the default configuration:
• Start the Network Assistant application, which is described in the getting started guide. Through this
• Use the CLI to configure the switch as a member of a cluster or as an individual switch from the console.
• Use the Cisco Prime Infrastructure application.
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
34
Crossover Cable
No
No
No
GUI, you can configure and monitor a switch cluster or an individual switch.
1
Straight-Through Cable
Yes
Yes
Yes
Switch Installation
OL-28309-02