Cisco Catalyst 2960-XR 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Catalyst 2960-XR에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-XR 25 페이지.
Cisco Catalyst 2960-XR에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (34 페이지), 하드웨어 매뉴얼 (20 페이지)

페이지 인쇄

RJ-45 Console Port

Procedure

Step 1

Connect the supplied RJ-45-to-DB-9 adapter cable to the standard 9-pin serial port on the PC. Connect the other end of

the cable to the console port on the switch.

Step 2

Start a terminal-emulation program on the PC.

Step 3

Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Step 4

Use the CLI to enter commands to configure the switch.

Switch Ethernet Management Port

Procedure

Step 1

Connect a Category 5 Ethernet cable to the PC Ethernet port. Connect the other end of the cable to the Ethernet management

port on the switch.

Step 2

Start a Telnet session on the PC.

Step 3

Enter the switch IP address that you assigned by using Express Setup.

Step 4

Use the CLI to enter commands to configure the switch.

Switch USB Mini-Type B Console Port

Procedure

Step 1

Connect an USB cable to the PC USB port. Connect the other end of the cable to the mini B (5-pin-connector) USB port

on the switch.

Step 2

Start a terminal-emulation program on the PC.

Step 3

Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Step 4

Use the CLI to enter commands to configure the switch. See the software configuration guide and the command reference

for more information.

You cannot use the RJ-45 console port and the USB console port at the same time. The USB console port takes

Note

precedence over the RJ-45 port when both are connected.