Cisco Catalyst 2960PD-8TT-L 시작하기 매뉴얼 - 페이지 7

{카테고리_이름} Cisco Catalyst 2960PD-8TT-L에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960PD-8TT-L 23 페이지. 8-port switches
Cisco Catalyst 2960PD-8TT-L에 대해서도 마찬가지입니다: 데이터시트 (11 페이지), 데이터시트 (21 페이지), 브로셔 및 사양 (10 페이지), 설명 (1 페이지)

페이지 인쇄

Click Submit to save your settings, or click Cancel to clear your settings.

Step 12

When you click Submit, the switch is configured and exits Express Setup mode. The PC

displays a warning message and tries to connect with the new switch IP address. If you

configured the switch with an IP address that is in a different subnet from the PC, connectivity

between the PC and the switch is lost.

Disconnect the switch from the PC, and install the switch in your network. See the "Managing

Step 13

the Switch" section on page 7 for information about configuring and managing the switch.

If you need to rerun Express Setup, see the "Resetting the Switch" section on page 18.

Refreshing the PC IP Address

After you complete Express Setup, you should refresh the PC IP address.

For a dynamically assigned IP address, disconnect the PC from the switch, and reconnect it to the

network. The network DHCP server assigns a new IP address to the PC.

For a statically assigned IP address, change it to the previously configured IP address.

Managing the Switch

After completing Express Setup and installing the switch in your network, use the device manager,

Cisco Network Assistant, or another of the management options described in this section for further

configuration.

Using the Device Manager

You can manage the switch by using the device manager that is in the switch memory. This is a web

interface that offers quick configuration and monitoring. You can access the device manager from

anywhere in your network through a web browser.

Follow these steps:

1. Start a web browser on your PC or workstation.

2. Enter the switch IP address in the web browser, and press Enter. The device manager page appears.

3. Use the device manager to perform basic switch configuration and monitoring. Refer to the device

manager online help for more information.

4. For a more advanced configuration, install Cisco Network Assistant as described in the next

section.