Cisco Catalyst 3032 시작하기 매뉴얼 - 페이지 12
{카테고리_이름} Cisco Catalyst 3032에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3032 34 페이지. Cisco systems catalyst blade switch getting started guide
페이지 인쇄Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Configuring the Switch
Configuring the Switch
Note
Connecting through the Switch Console Port
Step 1
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
12
To run the system configuration dialog, you must first connect the switch to a PC
to run a terminal emulation program. You can connect the switch to the PC: either
through the switch console port or through the DRAC/MC console port.
Instructions for these procedures are included in this section.
If you connect to the switch through the DRAC/MC, the switch console port is
disabled. After you have completed the configuration procedure, you must use the
disconnect command to close the active console port and re-enable the switch
console port. Type logout to log out of the switch, then enter Ctrl \ to disconnect
the DRAC/MC from the switch.
Follow one of these procedures:
To run the terminal emulation program through the switch console port, go to
•
"Connecting through the Switch Console Port" section on page
To run the terminal emulation program through the DRAC/MC port, go to
•
"Connecting through the DRAC/MC" section on page
Follow these steps when connecting through the switch console port:
Connect one end of the console cable to the switch console port. Connect the other
end of the cable to the serial port of the PC that is running the terminal emulation
application. (See
Figure
5.)
12.
14.
OL-14317-01