Cisco Catalyst 3110X 시작하기 매뉴얼 - 페이지 5
{카테고리_이름} Cisco Catalyst 3110X에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3110X 31 페이지. Catalyst switch module for ibm bladecenter
Cisco Catalyst 3110X에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (48 페이지)
페이지 인쇄
For more information about the features of each switch module, see the hardware installation guide
and the software configuration guide on Cisco.com.
Table 1
Catalyst Switch Module 3110G and 3110X Port Descriptions
Port
1
Ports 1 to 14
Ports 15 to 18
(Switch module 3110G)
Port 1 (X2)
(Switch module 3110X)
Internal 100BASE-T
Ethernet port
StackWise Plus ports
Console port
1. The number of internal ports is determined by the blade enclosure model. See the blade enclosure documentation for
more information about internal port numbering.
Catalyst Switch Module 3012
The Catalyst Switch Module 3012 is an 18-Gigabit Ethernet port, Layer 3 switch module. Up to 14 of
the Gigabit Ethernet ports are internal 1000BASE-X downlink ports that connect to the blade
enclosure. The other four Gigabit Ethernet ports are external uplink ports that provide connections to
other switches or routers. Figure 3 shows the switch module, and Table 2 describes the switch module
ports.
Description
Internal Gigabit Ethernet 1000BASE-X downlink ports that connect to the
blade enclosure.
External 10/100/1000BASE-T copper Gigabit Ethernet uplink ports that
support auto-MDIX and autonegotiation.
External 10-Gigabit Ethernet module slot for use with Cisco X2
transceiver modules.
The Ethernet management port (Fa0) is used only for switch module
management traffic, not for data traffic. It is connected to the aMM
through the blade enclosure backplane connector. Traffic to and from this
port is isolated from the switch ports. This port only supports
autonegotiation with 100 Mb/s and full-duplex mode.
Stacking cable ports.
Switch module management port (USB-to-DB-9connector).
5