FIBARO FGDW-002 운영 매뉴얼 - 페이지 8

{카테고리_이름} FIBARO FGDW-002에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGDW-002 16 페이지. Door/window sensor
FIBARO FGDW-002에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄

NOTE

Opening the casing

may result in trigger-

ing an alarm. To avoid

it, remove the asso-

ciations for the 3rd

group.

NOTE

Resetting the device is

not the recommend-

ed way of removing

the device from the

Z-Wave network. Use

reset procedure only

if the primary con-

troller is missing or

inoperable.

Certain

device removal can be

achieved by the pro-

cedure of removing

described in "Adding/

removing the device"

on page 5.

OPERATInG THE DEVICE

Resetting the Door/Window Sensor 2:

Reset procedure allows to restore the device back to its factory set-

tings, which means all information about the Z-Wave controller and

user configuration will be deleted.

In order to reset the device:

1. Open the cover.

2. Remove the battery.

3. Install the battery while holding both TMP buttons.

4. Release the TMP button within 5 seconds.

5. Visual indicator will blink 3 times to confirm launching of reset

procedure.

6. Wait around 30s for the resetting process to end, do not remove

the battery.

7. Visual LED indicator will blink 6 times to confirm the reset.

Replacing the battery:

In FIBARO Home Center controller current battery level is displayed

in the interface. If a battery icon turns red, it means the battery needs

replacement.

Notification report:

The device uses notification Command Class to report different

events.

notification Type

Home Security

Access Control

Power Management

Heat Alarm

Triggering Event

Tampering, product covering

removed

Door/window opened

Door/window closed

Replace battery now

Overheat detected, unknown

location

Underheat detected, unknown

location