FIBARO FGMS-001 운영 매뉴얼 - 페이지 5

{카테고리_이름} FIBARO FGMS-001에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGMS-001 20 페이지. Motion sensor
FIBARO FGMS-001에 대해서도 마찬가지입니다: 운영 매뉴얼 (2 페이지), 운영 매뉴얼 (11 페이지)

페이지 인쇄

#3: Adding/removing the device

Adding (Inclusion) - Z-Wave device learning mode, allowing to add

the device to existing Z-Wave network.

To add the device to the Z-Wave network:

1. Open the cover.

2. Place the Motion Sensor within the direct range of your Z-Wave

controller.

3. Set the main controller in (security/non-security) add mode (see

the controller's manual).

4. Quickly, three times press the B-button.

B-button

5. Wait for the adding process to end.

6. Successful adding will be confirmed by the Z-Wave controller's

message.

Removing (Exclusion) - Z-Wave device learning mode, allowing to

remove the device from existing Z-Wave network.

To remove the device from the Z-Wave network:

1. Open the cover.

2. Place the Motion Sensor within the direct range of your Z-Wave

controller.

3. Set the main controller in remove mode (see the controller's

manual).

4. Quickly, three times press the B-button.

B-button

5. Wait for the removing process to end.

6. Successful removing will be confirmed by the Z-Wave controller's

message.

NOTE

Adding

mode must be per-

formed up to 2 meters

from the controller.

NOTE

In case the Sensor is

not added, please re-

set the Sensor and re-

peat the adding pro-

cedure.

NOTE

Removing the device

from the Z-Wave net-

work restores all the

default parameters of

the device.

ADDInG/REMOvInG ThE DEvICE

security