Cisco Catalyst 3560 시작하기 매뉴얼 - 페이지 12

{카테고리_이름} Cisco Catalyst 3560에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3560 37 페이지. Compact switches
Cisco Catalyst 3560에 대해서도 마찬가지입니다: 제품 게시판 (3 페이지), 제품 게시판 (5 페이지), 브로셔 (17 페이지), 시작하기 매뉴얼 (20 페이지)

페이지 인쇄

• When placing the Catalyst 3560-8PC switch

on a flat horizontal surface without the

magnet, we strongly recommend that you

attach the rubber feet to the switch. Doing so

helps prevent airflow restriction and

overheating.

• Do not stack switches or place

Catalyst 3560-8PC switches side-by-side,

unless they are separated all around by at

least 3 inches (7.6 cm) of clearance from each

other.

• Do not wall-mount the Catalyst 3560-8PC

switch with its front panel facing up or to the

side. We recommend wall-mounting the

switch with its front panel facing down to

prevent airflow restriction and to provide

easier access to the cables.

Installation Warning Statements

This section includes the basic installation warning statements. Translations of these warning

statements appear in the Regulatory Compliance and Safety Information for the Catalyst 3560 Switch

document that shipped with the switch.

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this

equipment. Statement 148

Warning

To prevent the switch from overheating, do not operate it in an area that exceeds the

maximum recommended ambient temperature of 113˚F (45˚C). To prevent airflow

restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation openings.

Statement 17B

• Clearance to the switch front and rear panels

meets these conditions:

Front-panel LEDs can be easily read.

–

Access to ports is sufficient for

–

unrestricted cabling.

AC power cord can reach from the AC

–

power outlet to the connector on the

switch rear panel.

• Cabling is away from sources of electrical

noise, such as radios, power lines, and

fluorescent lighting fixtures.

• For 10/100 ports and 10/100/1000 ports, the

cable length from a switch to an attached

device cannot exceed 328 feet (100 meters).

• For cable lengths for small form-factor

pluggable (SFP) modules, see the

documentation that shipped with the

module.