Digisol DG-BG1100U 빠른 설치 매뉴얼 - 페이지 5
{카테고리_이름} Digisol DG-BG1100U에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digisol DG-BG1100U 16 페이지. Adsl2/2+ broadband router
페이지 인쇄
After installing the broadband router, you can verify its status from the LED indicators
on the front panel as shown below.
LED
Status
Name
Power
Link
Data
USB Driver Installation
Front View
Ethernet
USB
Rear View
Interface
RJ-11 port: Connect the router to ADSL connector or splitter
Line
through telephone line.
USB device interface for connecting to PC or other network
USB
devices.
RJ-45 port, for connecting the router to a PC or other network
Ethernet
devices through Ethernet cable.
To restore the factory default, keep the device powered ON,
Reset
insert a needle into the reset hole and keep the switch inside
pressed for about 1 second.
Power interface, for connecting the power adapter.
Power
ON / OFF
Power switch, on the side of power interface.
Switch
Off
Power is off.
On
Power is ON and the device operates normally.
Off
No signal is detected.
Blink
DSL line training is in progress.
On
DSL line connection is up.
Blink
Traffic is in progress.
Off
No signal is detected.
Blink
User data is going through Ethernet port.
On
Ethernet interface is ready to work.
Off
No signal is detected.
Blink
User data is going through USB port.
On
USB interface is ready to work.
5
Description
Description